Estes QCC Explorer build – Air intakes, papering fins, payload section
Used Avery Labels to paper the fins. They are thru-the-intake; not thru-the-tube.
Continue reading →Category Archives: Uncategorized
Wireless Launch Controller project
Building a wireless launch controller based on this ‘Rolling code HCS301 Transmitter Keyfob & 4 Relay Receiver Controls 12V 433.92MHZ‘ The box at the pad is powered by a Mighty Max 12v, 5 Amp battery, and includes a safety on/off … Continue reading →
The Chute Spool – Low Cost ‘Delayed’ Deployment
From an article by inventor Mr. Michael Moran (Peak of Flight Newsletter#531) It’s as simple as a tube (plastic straw) around a mounted dowel and string (Kevlar in this case) and polyester fabric. Had everything laying around; dollhouse shop supplies, … Continue reading →
Launchpad Build
This is the club’s first launch pad, which will accommodate four model rockets simultaneously. It will handle 1/8″, 3/16″, and 1/4″ rods. It will also sport our club wireless launch controller, also in the works.
Continue reading →Estes QCC Explorer Build
This is my first build in a few years. I found the QCC Explorer model very appealing, with it’s retro-futuristic look. It’s not too hard a build, although it’s a Skill Level 4 kit, probably for the complex engine … Continue reading →